Cadet CBC103TW User Manual download pdf (Page 4)

Operation & Maintenance

How to operate your heater

1. Once installation is complete and power has been restored, turn

the thermostat knob fully clockwise. (The thermostat is on the right.)

2. When the room reaches your comfort level, turn the thermostat

knob counterclockwise until the heater turns off. The heater will

auto mat ically cycle around this preset temperature.*

3. To reduce the room temperature,

turn the knob counterclockwise.

To increase the room tempera ture, turn the knob clockwise.

4. For additional heat beyond thermostat setting, when room is

occupied, turn timer to desired minutes. (The timer is on the left

and represented by the symbol . The numbers indicate minutes.)

Heater will remain on until time expires, then control of the heater

will return to the thermostat and the previous set

-point setting.

Maintenance

As needed, or every six months minimum.

. WARNING! Before removing grill, turn the electrical power off

at the electrical panel board (circuit breaker or fuse box). Lock or tag

the panel board door to prevent someone from accidentally turning

the power on while you are working on the heater. Failure to do so

could result in serious electrical shock, burns, or possible death.

. It is important that you verify power has been turned off and no

power is going to the heater before proceeding. Circuit breakers

are often not marked correctly and turning the wrong breaker off

could mean electricity is flowing to the heater, even if the heater

does not appear to be working. If you are uncomfortable working

with electrical appliances, unable to follow these guidelines, or do

not have

the necessary equipment, consult a qualified electrician.

3. Once you verify the power has been turned off correctly,

proceed to the next step.

4. Remove screws and take off grill.

5. Wash grill with hot soapy water and dry immediately.

6. While holding fan (to avoid damage or bending), use a hair dryer

or vacuum on blow cycle to blow debris through the top element

(do not touch element).

7. Vacuum fan area without touching the elements.

8. Replace grill and secure w

ith screws.

9. Turn thermostat to desired setting.

10. Turn power back on at the electrical panel board.

About the Manual Reset Temperature Limit Control

The heater is protected by a temperature-limiting control. The manual

reset temperature limit control is designed to open the heater circuit

when excessive operating temperatures are detected. The problem

must be assessed and the limit must be reset to re

sume operation.

Resetting the Manual Reset Temperature Limit Control

If the manual reset limit control has opened the heater circuit due to

excessive operating temperatures, the heater will not work until the

manual reset limit button is pressed. After allowing the unit to cool

for at least 10 minutes and resolving the problem causing the limit

to trip; use a narrow object such as a ball-point pen to a

ccess the

manual reset button through the lower-right center section of the

heater grill. Press FIRMLY and be sure to listen and feel for a click,

indicating it has been reset.

Figure 9

How do I insert the heater assembly into the wall can?

Turn heater assembly upside down (element down with motor facing you). Connect the supply wires to the

heater wires with connectors (See Figure 9). Now rotate the heater so the element and the fan are facing you.

The element should be at the top.

Insert the bottom edge of the heater assembly into the half round slots in the bottom lip of the wall can (See

Figure 10). [IMPORTANT: Push wires into bottom of wall can during insertion. Be sure that supply wires are not

caught between motor and wall can, attach assembly at top with screw provided.]

Secure grill with the screws provided. Slide thermostat

knob onto right control shaft extending through the grill

and the timer knob onto the left shaft. Turn power on at

the electrical panel board

STEP 3

Install Heater Assembly

STEP 4

Install Grill

Installation

Instructions

Warranty is void

if any material

is sprayed

on the element

or blower.

Figure 10

*Note: If thermostat knob is turned fully counterclockwise, it will be in the

disabled (no heat) position.

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Cadet CBC103TW User Manual Page 4

Comments to this Manuals

Related products and manuals for Space heaters Cadet CBC103TW