Cadet The Com-Pak Bath Heater CBC103TW User Manual download pdf

The

Com-Pak Bath

Heater

OWNER’S GUIDE FOR MULTI-VOLT MODELS

SAVE THESE INSTRUCTIONS

IMPORTANT INSTRUCTIONS

The Com-Pak Bath Heater

TOOLS REQUIRED:

Phillips Screwdriver

Straight Screwdriver

Wire Strippers

Utility Knife

(4) 1

/2" Wood Screws

(3) Insulated Wire Connectors

(1) Strain Relief Connector

WARNING

Turn the electrical power off at the electrical panel

board (circuit breaker or fuse box) and lock or tag

the panel board door to prevent someone from

turning on power while you are working on the

heater. Failure to do so could result in serious

electrical shock, burns, or possible death.

1. Read all instructions before using this heater.

2. Read all information labels. Verify that the electrical

supply wires are the same voltage as the heater.

3. All electrical work and materials must comply with the

National Electric Code (NEC), the Occupational Safety

and Health Act (OSHA), and all state and local codes.

4. Connect the grounding pigtail (copper wire) provided

in the wall can to the supply ground wire.

5. If you need to install a new circuit or need additional

wiring information, consult a qualified electrician.

6. Protect electrical supply from kinks, sharp objects, oil,

grease, hot surfaces or chemicals.

7. WARNING

Overheating or fire may occur. DO NOT install the heater

in a floor, in the ceiling, below a towel bar, behind a door, or

anywhere the air discharge may be blocked in any manner.

8. WARNING

Fire or explosion may occur. DO NOT install heater in any

area where combustible vapors, gases, liquids, or excessive

lint or dust are present.

9. WARNING

DO NOT install where heater is likely to get wet.

10. WARNING

Heater must be connected to a GFCI protected branch circuit.

11. WARNING

Burn Hazard. This heater is hot when in use. To avoid burns,

do not let bare skin touch hot surfaces. Use extreme caution

when any heater is used by or near children or invalids.

12. WARNING

Risk of Electrical Shock. DO NOT install the heater directly

above bathtub or sink. DO NOT install in shower stall area

(Manufacturer recommends a minimum 2 foot clearance).

13. WARNING

Risk of Electrical Shock. Connect grounding lead to grounding

wire provided. Keep all foreign objects out of heater.

14. WARNING

Risk of Electrical Shock. Never place a switch where it can

be reached from the tub or shower enclosure.

15. WARNING

Risk of Fire. Do not block heater. Heater must be kept clear

of all obstructions: a minimum of 3 feet in front, 6 inches

above and on both sides. Heaters must be kept clean of lint,

dirt and debris. (See Maintenance Instructions.)

www.cadetco.com Tel: 360-693-2505 P.O. Box 1675 Vancouver, WA 98668-1675

Features

Benefits

■

Thermal safeguard

•

High temperature manual reset:

turns off heater if normal operating

temperatures are exceeded

■

Commercial grade steel element - painted to resist rusting

■

Built-in controls

- Single pole thermostat with disabled (no heat) position

- 60 minute timer overrides thermostat for instant warmth

■

Powder coat paint process eliminates sharp cutting edges

■

Three year extended warranty on element and motor

■

Factory tested

■

Multi-Volt configurations

120 or 240 Volt AC (1000 Watts)

*Factory set at 240-Volts

Models:

CBC103TW or CB103T The Com-Pak Bathroom Heater

1/2” Depth

10” Width

12 5/8” Height

1 2 3 4 5 6 ... 11 12

Summary of Contents

Page 1 - Com-Pak Bath

The Com-Pak Bath HeaterOWNER’S GUIDE FOR MULTI-VOLT MODELSSAVE THESE INSTRUCTIONSIMPORTANT INSTRUCTIONSThe Com-Pak Bath HeaterTOOLS REQUIRED:Phillips

Page 2 - 8 inch from face of stud to

REJILLAOREJETAFuncionamiento y mantenimientoCómo hacer funcionar el calentador1. Una vez que se haya realizado la instalación y reestablecido laenergí

Page 3 - Instructions

GarantíaCONSULTE LOS CÓDIGOS ELÉCTRICOS LOCALES PARA DETERMINAR QUÉ TRABAJOS DEBEN SER REALIZADOS POR PERSONAL DE SERVICIO ELÉCTRICO CALIFICADOSíntoma

Page 4 - Operation & Maintenance

BLANK

Page 5 - IMPORTANT INSTRUCTIONS

Installation InstructionsHow do I install for new construction?Figure 1Face of wall can must extend ½ or 5/8 inch from face of stud toallow for thick

Page 6

Installation InstructionsWARNINGTurn the electricalpower off at theelectrical panelboard (circuitbreaker or fuse box)and lock or tag thepanel board do

Page 7

Operation & MaintenanceHow to operate your heater1. Once installation is complete and power has been restored, turn the thermostat knob fully cloc

Page 8 - SEGURIDAD

WarrantyCONSULT LOCAL ELECTRICAL CODES TO DETERMINE WHAT WORK MUST BE PERFORMED BY QUALIFIED ELECTRICAL SERVICE PERSONNEL.Symptom

Page 9

BLANK

Page 10 - Instale la rejilla

The Com-Pak Bath HeaterGUÍA DEL PROPIETARIO PARA MODELOS DE MULTIVOLTAJECONSERVE ESTAS INSTRUCCIONESINSTRUCCIONES IMPORTANTESThe Com-Pak Bath Heater1.

Page 11 - IMPORTANTES

Instrucciones para la instalación¿Cómo se instala el calentador en una construcción nueva?Figura 1La superficie de la cámara depared debe sobresalir e

Page 12

Instrucciones para la instalaciónADVERTENCIADesconecte laelectricidad en eltablero del paneleléctrico (caja decortacircuitos ofusibles) y trabe ocoloq

Comments to this Manuals

No comments

Cadet The Com-Pak Bath Heater CBC103TW User Manual

Browse online or download User Manual for Water heaters & boilers Cadet The Com-Pak Bath Heater CBC103TW. The Com-Pak Bath Heater

Summary of Contents

Comments to this Manuals

Related products and manuals for Water heaters & boilers Cadet The Com-Pak Bath Heater CBC103TW