Cadet BTF1A Installation Guide download pdf (Page 2)

Wiring Instructions - Part 1

INSTALLATION INSTRUCTIONS

Wiring Instructions - Part 2

BTF1

240/208

Volt

Application

BTF1

120 Volt

Application

BTF2

240/208

Volt

Application

GROUND

SCREW

GROUND

SUPPLY

GROUND

SCREW

GROUND

SCREW

GROUND

SCREW

GROUND

SCREW

GROUND

SCREW

GROUND

SCREW

GROUND

SCREW

GROUND

SCREW

GROUND

SCREW

1. All electrical work and materials must comply

with the National Electric Code (NEC), the Occu-

pational Safety and Health Act (OSHA), and all

state and local codes.

2. Use copper conductors only.

3. Turn off power to heater circuit at main discon-

nect panel.

4. Connect grounding lead to grounding screw

provided.

STEP 1

Turn the electrical power off at

the circuit breaker or fuse box.

STEP 2

Remove the junction box cover

at the end of the baseboard you

wish to wire.

STEP 3

Connect the supply grounding

wire to the green grounding

screw provided.

STEP 4

Disconnect one factory connector

on the side you have open,

leaving two loose heater wires.

IMPORTANT: If wiring on the

left side, disconnect ONLY

ONE factory connector!

A. Connect a hot supply wire to the red

thermostat wire.

B. Connect the black thermostat wire to

one of the heater wires.

C. Connect the remaining hot supply

wire to the remaining heater wire.

Proceed to Part 3.

A. Connect the hot supply wire to the

red thermostat wire.

B. Connect the black thermostat wire to

one of the heater wires.

C. Connect the neutral supply wire to

the remaining heater wire.

Proceed to Part 3.

A. Connect the black thermostat wires

to the loose heater wires.

B. Connect the hot supply wires to the

red thermostat wires.

Proceed to Part 3.

STEP 5

Refer to the instructions in Part 2 that correspond to your thermostat application.

Page 2

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Cadet BTF1A Installation Guide Page 2

Comments to this Manuals

Related products and manuals for Space heaters Cadet BTF1A