Cadet Softheat EBHN500-8 Operations Instructions download pdf (Page 5)

OPERATING INSTRUCTIONS

MAINTAINING YOUR HEATER

WARNING! Before cleaning, turn the electrical power off at the main disconnect panel (circuit

breaker or fuse box). Lock or tag the main disconnect panel door to prevent someone from accidentally

turning the power on while you are working on the heater. Failure to do so could result in serious

electrical shock, burns, or possible death.

1. The heater must be properly installed before it

is used.

2. DANGER: High temperatures may be gener-

ated under certain abnormal conditions. Do not

partially or fully cover or obstruct the front of this

heater.

3. If the heater over temperature limit trips more

than once per day, the heater must be replaced.

4. Clean heater at least every 24 months or as

required. See “Maintaining Your Heater” section.

5. Any other service not detailed in this Owner’s

Guide should be performed by an authorized ser-

vice representative.

Maintenance As Needed, or every 24 months minimum.

1. It is important that you verify power has been turned

off and no power is going to the heater before pro-

ceeding. Circuit breakers are often not marked cor-

rectly and turning the wrong breaker off could mean

electricity is owing to the heater, even if the heater

does not appear to be working. If you are uncomfort-

able working with electrical appliances, unable to fol-

low these guidelines, or do not have the necessary

equipment, consult a qualied electrician.

2. Once you verify the power has been turned off cor-

rectly, proceed to the next step.

3. Remove cover.

4. Wash cover with hot soapy water and dry.

5. Use a hair dryer, or vacuum on blow cycle, to blow

debris through the element (do not touch element).

6. Vacuum area without touching the element.

7. Replace cover and secure.

8. Turn thermostat to desired setting.

9. Turn power back on at the main disconnect panel.

How to operate your heater

The room temperature is controlled by a line voltage thermostat located either on the wall, or on

the heater. Once installation is complete and power has been restored, follow the steps below for

your thermostat.

If you have a mechanical thermostat:

1. Turn the thermostat knob fully clockwise.

2. When the room reaches your comfort level, turn the thermostat knob counterclockwise

until the heater turns off. The heater will automatically cycle around this preset temperature.

3. To reduce the room temperature, turn the knob counterclockwise. To increase the room

temperature, turn the knob clockwise.

If you have an electronic thermostat, follow the instructions in the programming and operating

guide included with your thermostat.

Page 5

1 2 3 4 5 6 7 8 9 10 ... 17 18

Comments to this Manuals

No comments

Cadet Softheat EBHN500-8 Operations Instructions Page 5

Comments to this Manuals

Related products and manuals for Space heaters Cadet Softheat EBHN500-8